Low Cost Automated Testing

Hardware Interfacing

The first step in setting up the FT-100a for any test or control task is to establish the interface between the unit-under-test (UUT) and the FT-100a I/O connectors.  This interface may be done in many different ways, often by a simple cable or "interface box".  Y-tek offers an FT100 Connector PCB to assist in the interface to the UUT. The FT-100a comes with 30 inch cables with which to connect to the interface.  Even power supply voltages are provided in the FT-100a I/O interface.  All aspects of hardware interfacing are covered in detail in the FT-100a Operator's Manual.